1.75mm/3.0mm 3Dプリンター J-Headホットエンド用 ストレート 差し込み式 エア継手 ねじ付き

Finally, a fitting that actually stays put—I’ve had other push-in connectors wiggle loose over time, but this one grips the tubing firmly even with 3.0 mm PTFE. The threads were machined cleanly and seated perfectly into my J-head hotend without any binding.

The threads on this fitting were perfectly clean and cut, so it screwed into my J-Head block smoothly without any cross-threading. My 1.75mm PTFE tube locked in tight with no wiggle at all.

Finally stopped getting that annoying wiggle where the PTFE tube meets the hotend, this push-in fitting locks it down tight for my 1.75mm Bowden setup. The thread seated perfectly on the J-head and the release ring is easy to push when I need to swap filament.